British Columbia · Energy · checked September 28, 2026

Heat loss calculations in Burnaby

The heat loss calculation is how a heat pump or furnace gets sized for your house, and the key input is the design temperature: −4.4°C for Burnaby, from NRCan's HOT2000 climate data for Vancouver International.

Get matched in Burnaby → The CSA F280 heat-loss calculation
A kitchen table with a house floor plan, a laser measure, a tape measure and a laptop showing the plan

Design temperature

−4.4°C

Heating degree-days

2,768

Standard

CSA F280

Typical cost

$150–$400 standalone

How Burnaby is built

Burnaby's houses by when they were built Ten house shapes, one for each tenth of Burnaby's 47,540 houses. Before 1961: 18%, 1961–1990: 40%, 1991–2000: 15%, 2001 or later: 27%. Older houses glow hotter.
  • Before 1961 18%
  • 1961–1990 40%
  • 1991–2000 15%
  • 2001 or later 27%
Each house stands for one in ten of Burnaby's 47,540 houses (single-detached, semi-detached, row and duplex), drawn by when it was built. The glow shows the usual pattern: older houses tend to be leakier and less insulated. Snowfall scales with heating degree-days. Sources: Statistics Canada 2021 Census (table 98-10-0233-01), NRCan HOT2000 climate data.

Why the design temperature matters in Burnaby

−4.4°C is the 6th-mildest design temperature of the 70 cities we cover. The F280 calculation works out how much heat each room loses on that design day, from the house's actual walls, windows, air leakage and ceiling insulation.

With a design day that mild, a heat pump sized to the calculation can carry most or all of a typical Burnaby house's heating load, which makes sizing it right, rather than oversizing it, the main job.

In the Vancouver area, 32% of households heat mainly with a forced-air furnace, 31% with electric baseboards, 12% with a boiler and radiators and 5% with a heat pump; natural gas is the main heating energy for 42% of households and electricity for 39% (Statistics Canada, 2023).

Why skipping it costs money

Contractors who size by square footage routinely oversize. An oversized heat pump costs more to buy, cycles on and off, dehumidifies poorly in summer and wears faster. An undersized one leans on backup heat. The F280 report is the evidence either way, and it's worth having before you compare quotes.

What it costs

About $150–$400 as a standalone calculation (a September 2026 planning range; quotes vary). Many energy advisors bundle it with an EnerGuide evaluation, which also gives the calculation measured air-leakage data instead of an assumption.

NRCan-licensed service organizations serving Burnaby

Many energy advisors also do room-by-room CSA F280 calculations for an extra fee; HVAC designers do them too. Ask for the F280 report itself, not just an equipment recommendation.

Source: NRCan list of licensed service organizations, checked September 28, 2026. Call to confirm your street is covered and ask about wait times.

Heat pump programs in Burnaby

Provincial · needs an evaluation BC Home Energy Improvement Bonus $20 for every percentage-point your home improves — $750 minimum, $2,000 maximum — or $300 for any two upgrades Open Provincial CleanBC Energy Savings Program Free energy-saving upgrades for income-qualified BC households — insulation, heat pumps and more, installed at no cost Open · deadline Federal CMHC Eco Improvement premium refund 25% back on your CMHC mortgage insurance premium after $20,000 of energy renovations Open Federal Canada Greener Homes Affordability Program Free retrofits for low-to-median-income households in BC, Manitoba, Nova Scotia, PEI and Quebec — not available in Ontario Open · deadline

Heat loss calculation in Burnaby: common questions

What design temperature is used for heat pump sizing in Burnaby?

NRCan's HOT2000 climate data gives −4.4°C for Vancouver International. Your designer may use the building code's design value for Burnaby, which can differ slightly; ask which one the calculation uses.

How much does a heat loss calculation cost?

About $150–$400 standalone as a planning range; often less when bundled with an EnerGuide evaluation.

Who does F280 calculations in Burnaby?

Many of the 29 NRCan-licensed organizations serving Burnaby offer them, as do HVAC designers. Ask for the F280 report itself.

Do rebate programs require a heat loss calculation?

Requirements vary by program and change often. Even where it isn't required, it is the best protection against an oversized or undersized system.

Heat loss calculation near Burnaby

Heat loss calculation in Coquitlam8 kmHeat loss calculation in Vancouver10 kmHeat loss calculation in Richmond14 kmHeat loss calculation in Delta16 kmHeat loss calculation in Surrey17 km All 70 cities →

Sources

Checked September 28, 2026. Census figures are for the municipality (British Columbia); climate data is NRCan's HOT2000 station Vancouver International (16 km away).

Get matched with a registered advisor in Burnaby

Tell us your postal code and what you’re planning. We’ll connect you with one licensed service organization serving your area. No spam, no shared lead lists.

Email us what you’re planning, your postal code and the type of building (a house, a duplex or triplex, or a larger multi-unit building) — we’ll reply with registered service organizations for your area and which rebates apply.

Email dave@clickshift.ca

This inbox is answered by a person. Participating advisors pay us a referral fee — you pay nothing, and it never affects the directory.