British Columbia · Energy · checked September 28, 2026

Combustion safety testing in Kamloops

A combustion safety test checks that your furnace, water heater and fireplace vent their exhaust outside instead of into the house, which matters most right before and after you tighten the house up. In the Kamloops area, the main heating energy is natural gas for 90% of households.

A gloved hand inserting a combustion analyzer probe into a furnace flue pipe in a basement

Cost

Included with an evaluation

Natural gas heat

90%

Gas distributor

FortisBC

CO alarms required (existing homes)

No

How Kamloops is built

Kamloops's houses by when they were built Ten house shapes, one for each tenth of Kamloops's 32,450 houses. Before 1961: 11%, 1961–1990: 51%, 1991–2000: 15%, 2001 or later: 24%. Older houses glow hotter.
  • Before 1961 11%
  • 1961–1990 51%
  • 1991–2000 15%
  • 2001 or later 24%
Each house stands for one in ten of Kamloops's 32,450 houses (single-detached, semi-detached, row and duplex), drawn by when it was built. The glow shows the usual pattern: older houses tend to be leakier and less insulated. Snowfall scales with heating degree-days. Sources: Statistics Canada 2021 Census (table 98-10-0233-01), NRCan HOT2000 climate data.

Why it matters in Kamloops

In the Kamloops area, 83% of households heat mainly with a forced-air furnace; natural gas is the main heating energy for 90% of households (Statistics Canada, 2023).

The risk rises after air sealing: a tighter house plus a strong exhaust fan or dryer can pull exhaust back down a chimney. That's why advisors test for spillage during an evaluation and why it should be repeated after serious tightening.

The CO alarm rule in British Columbia

B.C. doesn't require CO alarms in existing homes; the province recommends them wherever there's a fuel-burning appliance, fireplace or attached garage, and the building code requires them in new homes.

What the check involves

  • Worst-case depressurization: exhaust fans and the dryer on, doors set to make the appliance room as negative as it gets.
  • A spillage and draft check at each appliance, with a CO reading.
  • A plan if anything fails: often a sealed-combustion appliance or a fix to the venting, done by a licensed gas or oil technician.

The combustion safety check in detail.

NRCan-licensed service organizations serving Kamloops

Energy advisors check for combustion spillage during an evaluation; fixing a venting problem is work for a licensed gas or oil technician.

Source: NRCan list of licensed service organizations, checked September 28, 2026. Call to confirm your street is covered and ask about wait times.

Programs in Kamloops

Combustion safety test in Kamloops: common questions

Are CO alarms required in Kamloops homes?

B.C. doesn't require CO alarms in existing homes; the province recommends them wherever there's a fuel-burning appliance, fireplace or attached garage, and the building code requires them in new homes.

Who does combustion safety testing?

Energy advisors check for spillage during an EnerGuide evaluation. Repairs to venting or appliances are done by a licensed gas or oil technician.

I have CO alarms. Isn't that enough?

Alarms warn you once CO is already in the house. A spillage test finds a venting problem before it produces CO.

Combustion safety test near Kamloops

Get matched with a registered advisor in Kamloops

Tell us your postal code and what you’re planning. We’ll connect you with one licensed service organization serving your area. No spam, no shared lead lists.

Email us what you’re planning, your postal code and the type of building (a house, a duplex or triplex, or a larger multi-unit building) — we’ll reply with registered service organizations for your area and which rebates apply.

Email dave@clickshift.ca

This inbox is answered by a person. Participating advisors pay us a referral fee — you pay nothing, and it never affects the directory.